MaxTech PCN2000 Series Manuel d'utilisateur télécharger pdf (Page 12)

218 ZENworks for Desktops 3.2 Administration Guide

Novell Confidential Manual (99a) 11 September 2003

At the master computer, type m > press Enter.

7 At the master computer, after all the other computers have registered as participants, type g >

press Enter.

The imaging engine begins creating the image of the master computer and the image is sent

to and laid down on each participating computer. Any problems are reported back and

displayed on the master computer.

8 At each participating computer, when the imaging is done, do the following to boot the

computer with the new operating system:

8a At the Linux prompt, type lilo.s > press Enter.

8b Press Ctrl+Alt+Delete.

HINT: If the computer doesn’t boot to the new operating system (that is, if the Linux prompt

reappears), enter the lilo.s command again and reboot the computer a second time.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Pas de commentaire

MaxTech PCN2000 Series Manuel d'utilisateur Page 12