MaxTech NXP-16 Guide de l'utilisateur Page 1

Part #MAN107 Rev. 1.0 NX16BT/DNXP-16USER'S GUIDEHigh PerformancePlug and Play16-bit EthernetAdapter

9functioning. If you suspect that the adapter ismalfunctioning, replace it with another adapterwhich is known to function properly. Also try theadapte

10nators. If the terminators do not measure 50 ohms+/- 1%, replace the terminator. Measure the coaxialcable with a 50-ohm terminator attached to oneen

11I/O address: 200, 220, 240, 260, 280, 2A0, 2C0,2E0, 300, 320, 340, 360, 380, 3A0,3C0, 3E0IRQ line: 2 (9), 3, 4, 5, 10, 11, 12, 15RAM buffer: 16 KBBo

12World Wide Web - www.maxcorp.comEmail - [email protected] - ftp.maxcorp.comSection Eight - Notices8.1 Five Year Limited WarrantyMaxTech warrant

13the unit by any unauthorized service center. This warranty isvoided if the product has been abused, misused, modified,or repaired by an unauthorized

14document in any form is allowed without written permissionfrom the manufacturer.First Edition GZ/DR - Version 1.0

15

1ContentsSection One - Introduction ... 1Section Two - Installation ... 2Section Three - Driver Installa

2Section Two - InstallationThis section provides step-by-step instructions onhow to install your new network adapter. Installationof this network adap

3before installation. Discharge any static electricityfrom your body by touching any metal surface.1. Turn off your computer and all peripherals.2. Ma

4Section 2.3.1 for all Windows 95 systemsSection 2.3.2 for PnP systems without Win-dows 95Section 2.3.3 for Non-PnP Systems2.3.1 Configuration in Wind

5B:\WIN95) in the entry box and click “OK”. Click“Finish.”Windows 95 may request its own installation disksor CD for some files. Insert the Windows 95

6For more information on running SETUP, refer tothe file README.TXT in the root directory of thedriver diskette.The following configuration options ar

7cable is attached (and properly terminated if usinga BNC connection) to the adapter when using thisoption. If any test has a fail count, press thespa

8ning the SETUP program.3. Follow the Remote Boot Workstation instal-lation procedure given in your network oper-ating system manual (i.e. create a Bo